Rywire Motorsport Electronics

Porsche wiring harness for Emtron Computer

This kit is pre-wired for the following components, and does NOT include these components unless otherwise mentioned.
We have designed this system to be the the highest level install available for our customers. You must purchase the Emtron computer and Rywire P14 PDM devices to be able to power this system on, we have come up with this design around these 2 controllers.

- KV8 Emtron computer connections with Ethernet connection
- P14 PDM connections (power source, solid state "fuse box")
- Accelerator pedal connector for drive-by-wire
- Spare PDM outputs for spare pumps,motors,etc.
- CAN bus connectivity/expansion for CAN open devices.
- Milspec FIREWALL disconnect plug separates main loom into 2pcs
- Injector Dynamics 1050X injector connections.
- Denso or V.A.G. coil pack connections.
- Multiple head grounds for coils/ecu/sensors
- Milspec disconnect lower coil pack sub harness for twin spark engines.
- Right and Left lambda sensor connections for Bosch lsu 4.9 sensors
- Milspec disconnect upper and lower bank harness disconnects for ease of installation
- Integrated fuel temp and pressure sensor connector (we will offer ordering information for sensor)
- Oil pressure gauge wiring for factory cluster installs
- Oil temp gauge wiring for factory cluster installs
- Oil level gauge wiring for factory cluster installs
- Head temp wiring for factory head temp sender
- Factory 964/993 crank sensor wiring
- Clewett hall cam sensor prewired
- Updated 993 Knock sensor wiring
- Alternator 12v (excite/on) wiring
- DBW wiring, If applicable
- Selectable Flapper control/Boost solenoid control
- Bosch MAP/T Manifold pressure/Temp sensor wiring
- Bosch PG sensor wiring


Recommended installation with our wiring kit is the Porsche 911 specific Kinsler dual DBW ITB system. Or the AT Power single DBW ITB system.

The below video covers the Motec system installation, however because of shortage of stock from Motec, we will only be supporting the Emtron system at this time.

No computers are included in this system. Rywire PDM an Emtron computer required for proper installation.

These harnesses have a lead time, expect up to 30days.